|
Mercury
Work Group
Phase II Reports >> Technology Identification Subgroup Report
Facilities Loadings
| Pretreatment Manual |
Tech. Identification
Hg Management Guidebook | Mercury Products
Database
For more
information, contact David Eppstein by email at
deppstein@masco.harvard.edu,
or by calling 617-632-2860.
Disclaimer
This
Report is a product of the Technology Identification Subgroup of
the Phase II MWRA/MASCO Mercury Work Group, End-of-Pipe
Subcommittee. All expressed opinions, suggestions,
recommendations, and conclusions in this Report are those of the
Subgroup and not necessarily those of any participating person
or institution, including MASCO and the MWRA.
The
Work Group, the Subcommittee, the Subgroup, and participating
persons and institutions, including MASCO and the MWRA, make no
warranty or representation of any kind regarding the information
in this Report, including, without limitation, accuracy,
application, compliance with any law or regulation, or any other
purpose. These parties shall not be held responsible,
individually or jointly, for any actual or consequential damages
that may result from use of the information contained in this
Report.
This
Report is not intended to be an endorsement of any outside
company or vendor of a pretreatment technology by the Work
Group, the Subcommittee, the Subgroup, or any of its
participating persons and institutions, including MASCO and the
MWRA, nor is this Report a comprehensive review of existing
vendors of pretreatment technologies that could be applied to
mercury-containing wastewater streams.
It must
be emphasized that the bench-scale tests described in this
Report were intended to determine only technical feasibility and
were performed on samples of a particular wastestream. Results
of similar testing on other wastestream samples may differ.
Furthermore, because of the limited nature of bench-scale
feasibility testing, any descriptive information and cost
estimates provided by vendors relative to full-scale
pretreatment systems should be considered as preliminary only.
The
bench-scale feasibility test reports, found in Appendix F, were
written by the respective vendors. The information in these
reports has not been verified by the MWRA/MASCO Mercury Work
Group.
RETURN
TO TECHNOLOGY IDENTIFICATION SUBGROUP REPORT
TABLE OF CONTENTS
|
